AHU Coil Cleaning Chemicals
The Problem: Contaminated Evaporator/Condenser, AHU Coils
Dirt, Soot and Grimy Deposit
Oxide Film Build-up
Reduced Air-flow
Lower Cooling Efficiency
Reduced Evaporator / Condenser Life
Frequent Compressor Failure
Increased Energy Consumption Per Ton of Refrigeration
The Solution: Vaniklin- WB treatment
Cleans, renders good-as-new, coils, condenser surfaces and filters
Brightens, removes tarnish
Provides free, unhindered air circulation
Enhances cooling
Increases life span of condenser & evaporator coil
Provides trouble-free compressor performance
Reduces energy consumption per ton of refrigeration
Product Features
No steaming, scrubbing of brushing required
Supplied in highly concentrated form
Non-corrosive to most metals including brass, aluminm, copper, mild steel
Safeto handle and dispose
No special storage required
General Directions For Use
Shut off system. In certain cases, e.g. comfort A/C jobs, this may not be necessary.
Mix 1 part Vaniklin-Wb with 1 part water. For less stubborn deposits, use higher dilution ratio (1:2 or 1:3).
Spay directly onto coil using a low-pressure hand sprayer. (For multi-bank coils, a mechanical spray pump may be needed). Spray directly over entire surface to be cleaned.
Rinse thoroughly with water after 3-5 minutes or when foam settles. Dirt is lifted, in fact, it just vanishes.
Window units can be easily cleaned by dipping into 1:1 solution of Vaniklin-Wb for 3-5 minutes.